Wireless Access Point Installation Tips

|

Wireless Access Point Installation Tips

While assembling your wireless access point, be sure to follow all the manufacturer’s instructions. Follow the setup wizard if it has one, and call customer support if you run into trouble. The initial configuration of your AP requires a PC or laptop with an RS-232 cable connected. You should mount the APs in a safe location and ensure they’re out of reach. Most wireless AP vendors don’t include a nine-pin RS-232 cable.

When installing multiple APs, write down their locations and mark them on a floor plan map. It’s also helpful to take a picture of each AP after installation. This documentation will prevent you from forgetting where you placed each AP, and will help others find them if you’re away. Listed below are some other wireless access point installation tips. Keep reading for a better understanding of WiFi installation. Take advantage of these tips to stay connected.

Install wireless access points according to manufacturer’s instructions. While some access points are ceiling or wall-mounted, others are designed to sit on a desk. Some even limit their broadcasting range to 30 degrees or 45 degrees, so make sure to follow the manufacturer’s installation instructions before putting your new wireless access point up. Also, keep in mind that you should install your wireless access point in an open area, away from obstructions, and not too close to other technology.

The placement of your wireless access point will determine the area where the most interference occurs. Consider placing the AP at a distance from your wireless routers and microwaves, as they can sabotage your wireless network. In rural areas, there is no need to worry about interference from nearby WiFi networks, but in densely populated urban areas, interference can be significant. Check WiFi networks in your area to determine which channels are best for your access point.

After connecting your wireless access point to your network switch, you’ll need to connect the device to a broadband router or network switch. Then, connect the wired router or network switch to your access point using a data or Ethernet cable. The access point will send and receive a Wi-Fi signal to a designated area. Once installed, you’ll be able to access the internet and other devices. You can even install a wireless access point in your reception area for guests to use.