Wireless Access Point Installation Tips

|

Wireless Access Point Installation Tips

Despite the ease of use of WiFi, some people struggle to install their wireless access point. That’s where these tips come in. These installation tips will help you set up your WiFi network to ensure that it will work efficiently for years to come. Follow these simple guidelines to get the most out of your new WiFi network. Read on to learn more! We’ve collected 7 WiFi installation tips to help you install your new WiFi device in the best way possible.

– Do a Wi-Fi site survey. Before you install your new wireless access point, do a Wi-Fi coverage check. To check if the new wireless signal is present, walk around with a device and look at the signal strength. The AP must have excellent signal strength to provide high-quality coverage. In order to avoid any problems, keep in mind that you’re installing a wireless network, not a phone charger.

– Install the wireless access point properly. Some models are wall or ceiling-mounted. Others are desk-top units. Others have sectorized antennas. You should be sure to follow the instructions on the label. If you have any doubts, consult the manufacturer. If all else fails, use a professional. Listed below are some wireless access point installation tips that should help you get the best performance from your network. You’ll be glad you did.

– Mount the wireless access point securely. Afterwards, mount it in a convenient location. If you’re a novice, you might run into trouble installing your new wireless access point. If you have any doubts, call the manufacturer’s customer service or consult with an expert. During the initial configuration process, a PC or laptop should be connected to the access point via a nine-pin RS-232 cable. Mount the AP so that it’s out of reach of kids and pets.

Consider using Cat5 or Cat6 cable. Cat6 cables have higher throughput and less potential for cross-talk interference. While Cat5 is a relatively inexpensive cable, it may need replacing sooner or later. However, remember that Cat5 and Cat6 cables have certain limitations, and can’t run over 100 meters. Therefore, if you’re trying to run a long distance, you may need to use a different technology. Fiber optic cables will provide more distance.

– Change the administrator password. Default passwords are not secure. It’s recommended that you change your administrator password to something that’s easy to remember for those who maintain your wireless access point. Moreover, make sure the SSID (service set identifier) of each AP is easily recognizable for the people who will be using it. If you’re not sure how to do this, don’t worry – there are simple tips to install and configure your wireless access point.

Consider the coverage area. Wireless access points should be placed in locations where they can reach the largest area. The go-to spot is almost always the center of a room. However, this is not always possible. In this case, it is important to select the best location based on daily usage. The wireless signal must reach the access point before moving to another area. Then, keep in mind that other wireless networks may be transmitting signals in the area.