Wireless Access Point Installation Tips

|

Wireless Access Point Installation Tips

If you’re planning to install a wireless access point, you might want to use these tips. Identify where each AP should be located and label them accordingly. If there are multiple APs, you should label them in colors that match the surrounding area. You can also take pictures or make floor plans to label the AP locations. Lastly, make sure to keep cabling out of sight. You can hide wires and cables with false ceiling tiles or use lockable network racks or cabinets.

Before installing wireless access points, you must perform a Wi-Fi site survey. Doing this will help you determine which areas will be covered by your network. Depending on the location, you can walk around the building and test the coverage by using a WiFi-enabled device. If the coverage is adequate, you can install APs strategically around the building. However, you should avoid placing them in areas where they will be blocked by other devices or technology.

To choose the right wireless access point, you should consider how many devices will use it. You should also consider what types of online activities will take place in that area. You should use a spreadsheet or notes to keep track of all these things. By knowing these things beforehand, you will have an easier time finding the right access point. This task is not easy, especially because there are so many wireless access points to choose from. This wide variety can even confuse wireless professionals.

When purchasing a wireless access point, you should choose one that has advanced security features. Modern access points support a variety of encryption schemes, including WPA2 for the strongest security. Older models only support WEP, which has been proven to be inadequate against modern attacks. When choosing an access point, make sure to choose a password that is not easily guessed. Also, remember to connect your access points to backup batteries so that they are never left without power. If the power goes out, wireless users will be disconnected.

A wireless access point creates a WiFi network. It is connected to a wired router or a network switch via an Ethernet cable. It projects a wireless signal in the 2.4Ghz or 5Ghz range. Installing a wireless access point can allow you to have Wi-Fi access in your reception area or other designated area. However, you should also check the wiring to ensure that your access point is protected from interference.